08-24-2020 07:54 AM
Recently installed the Cisco RV345 to take advantage of load balancing and WAN failover for our small business. An employee is having issues now with a bank, because of the dual WAN the IP sometimes changes during the session and the bank isn't allowing certain transactions because they require a persistent IP. Is there a way to lock a LAN port on the router to only use one particular WAN? I can't seem to find anything on the interface that would allow this function. Thanks for your help!
Solved! Go to Solution.
08-24-2020 08:31 AM
Not sure if your version of RV345 hve Policy based routing- check under networking --routing--Policybased routing available
then you can use based on the IP address rouce to send to different WAN.
is that works for you ?
08-24-2020 08:42 AM
Hello,
go to Step 5 in the Multi-Wan section of the admin guide (page 45) attached. There you can set the source/destination/outgoing interface...
https://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/RV340/Administration/EN/b_RV340x_AG.pdf
08-24-2020 08:31 AM
Not sure if your version of RV345 hve Policy based routing- check under networking --routing--Policybased routing available
then you can use based on the IP address rouce to send to different WAN.
is that works for you ?
08-24-2020 08:37 AM
Missed the Policy Binding Table when I was searching. Thanks so much for your help.
08-24-2020 08:42 AM
Hello,
go to Step 5 in the Multi-Wan section of the admin guide (page 45) attached. There you can set the source/destination/outgoing interface...
https://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/RV340/Administration/EN/b_RV340x_AG.pdf
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide