Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
375
Views
0
Helpful
3
Replies

config int. to use ISP DHCP

Go to solution
shanemcanuff
Level 1
Level 1

‎11-19-2008 09:47 AM - edited ‎03-04-2019 12:24 AM

I have a 2600 router and want to connect it to my ISP, how do I config.. the interface to use the ISP DHCP?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Mark Yeates
Level 7
Level 7
In response to shanemcanuff

‎11-19-2008 10:30 AM

If all you need is an IP address from your ISP on your router then yes.

Mark

View solution in original post

0 Helpful
3 Replies 3

Go to solution
Mark Yeates
Level 7
Level 7

‎11-19-2008 09:55 AM

Shane,

You should configure the port connected to your ISP with the following interface command (ip address dhcp".

HTH,

Mark

0 Helpful

Go to solution
shanemcanuff
Level 1
Level 1
In response to Mark Yeates

‎11-19-2008 10:18 AM

and that is the only command I should put on the interface?

0 Helpful

Go to solution
Mark Yeates
Level 7
Level 7
In response to shanemcanuff

‎11-19-2008 10:30 AM

If all you need is an IP address from your ISP on your router then yes.

Mark

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card