Solved: Configure IRB/BVI on CSR1000v

CiscoBrownBelt · ‎05-20-2020

So certain commands such as choosing IEEE protocol are not an option. Neither is configuring a VLAN in the VLAN database or adding the "bridge group" to a interface. Not sure if it is this VIRL CSR1000v or what but I can't find documentation for how to configure this on a CSR1000v. Any help?

Georg Pauwen · ‎05-20-2020

Hello,

I think the CSR1000v has VxLAN support only; bridge groups are obsolete, and you need to use bridge domains instead...

View solution in original post

paul driver · ‎05-21-2020

Hello
CSR1000v is a router not a switch so no switch virtual interfaces (SVI) and IRB/BVI is now replaced with Bridge Domain Interfaces.(BDI), however ive not checked if this Virl vm supports it.

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

Georg Pauwen · ‎05-20-2020

Hello,

I think the CSR1000v has VxLAN support only; bridge groups are obsolete, and you need to use bridge domains instead...

paul driver · ‎05-21-2020

Hello
CSR1000v is a router not a switch so no switch virtual interfaces (SVI) and IRB/BVI is now replaced with Bridge Domain Interfaces.(BDI), however ive not checked if this Virl vm supports it.

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul