Configure X.25 comunication on HWIC-2T

[IlyaMichlin]

I have the CISCO 1800 and I have there the HWIC-2T. I have two questions.

First is an easy one. I want to replace the HWIC-2T with HWIC-4T but the CISCO 1800 guide and the HWIC-4T guide says that they dont fit together but I inserted the HWIC-4T in to the CISCO 1800 it recognized him with all the 4 Smart Serial ports that it hase. The question is, how can I check if the CISCO 1800 supports the HWIC-4T?

Second question is how can I configure one of the Smart Serials in the HWIC-2T/4T to comunicate with the X.25 Protocol? What I have now is at one end CISCO 1800 and at the other end CISCO 2800 and they are comunicating with each other throught one of the Smart Serials they have. I want to connect to each one of then an old pc that comunicate only with X.25 and I want this two computers to comunicate with each other throught those two routers.

Im a bit new to router confiruration so please help.

[paolo bevilacqua]

Q1:it if work, it works and there is nothing to check further.

Q2: can be done. Note unless you are willing to loose a lot of time, gain frustration, and not get sure results, give the job to a reputable consultant, or certified Cisco partner (even if admittedly there is not much people anymore with X,25 skills).

[Peter Koltl]

My dear oldskool friend (-:

interface Serial1/0

description ***** XOT ATM  *****

bandwidth 9

no ip address

encapsulation x25 dce

x25 win 7

x25 wout 7

x25 ips 256

x25 ops 256

x25 route 3333000002 xot 10.0.10.253 xot-source Loopback0

http://www.cisco.com/en/US/partner/tech/tk713/tk730/technologies_q_and_a_item09186a00800a3c0b.shtml

http://www.cisco.com/en/US/partner/tech/tk713/tk730/technologies_configuration_example09186a0080093c0e.shtml