06-02-2014 05:19 PM - edited 03-04-2019 11:04 PM
Hello colleagues,
I cannot connect fiber optic network device ADVA FSP 150 CC to Cisco 2911. I connected the device directly to computer and it worked well but I couldn't make it through the router. IP and DNS are static. To connect devices I use RJ-45 rollover cable.
Here is the info:
Bandwidth: 10Mb
IP Block: 24.43.28.248 /30
Subnet: 255.255.255.252
Gateway: 24.43.28.249
Usable IP range: 24.43.28.250
DNS1: 209.18.47.61
DNS2: 209.18.47.62
Speed: 100
Duplex: Full
Could you please tell me what is the possible problem is,
Here is Show run listing
!
!
!
ip dhcp excluded-address 10.10.10.1
ip dhcp excluded-address 192.168.1.1 192.168.1.10
!
ip dhcp pool ccp-pool
import all
network 10.10.10.0 255.255.255.248
default-router 10.10.10.1
lease 0 2
!
ip dhcp pool DHCP_POOL
network 192.168.1.0 255.255.255.0
default-router 192.168.1.1
dns-server 192.168.2.1
domain-name OmniaLocal1
!
!
!
ip domain lookup
ip domain name yourdomain.com
ip name-server 209.18.47.61
ip name-server 209.18.47.62
no ipv6 cef
multilink bundle-name authenticated
!
!
interface Embedded-Service-Engine0/0
no ip address
!
interface GigabitEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$
no ip address
duplex auto
speed auto
!
interface GigabitEthernet0/1
ip address 24.43.28.250 255.255.255.252
ip nat outside
ip virtual-reassembly in
duplex full
speed 100
!
interface GigabitEthernet0/2
no ip address
ip nat inside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet0/2.1
encapsulation dot1Q 1 native
ip address 192.168.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly in
!
ip forward-protocol nd
!
ip http server
ip http access-class 23
ip http authentication local
ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
!
ip nat inside source list 1 interface GigabitEthernet0/1 overload
!
access-list 1 permit 192.168.1.0 0.0.0.255
access-list 23 permit 10.10.10.0 0.0.0.7
!
!
!
control-plane
!
!
06-03-2014 08:49 AM
Hi there,
Please try using straight over cable or set the cisco side interface as below
Speed=auto
duplex=auto
HTH
Hitesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide