Connect to Different Sub-Networks with a Router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2021 09:09 AM - edited 12-30-2021 09:13 AM
Can anyone please assist me on how to connect two subnetworks like given in the PKT here?
I have also attached a table including the IP Addresses and the question..
I have already completed task 1-3. Need help regarding the 4th one.
- Labels:
-
Routing Protocols

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2021 09:32 AM
Hello,
are these the full instructions ? There is no indication of how the routers are to be connected, through which interfaces, and which subnet is supposed to be used for which connection ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2021 09:41 AM - edited 12-30-2021 09:43 AM
@Georg Pauwen Thanks for reaching out. Yes, these are the full instructions. I have completed the other two sub networks and they work fine. I am just stuck with the 'Gotham' Part and what to do with it. You can use 192.168.24.1/22 or any other IP as per your liking in Gotham since the table is manually generated by me, so I can make further changes.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2021 01:12 PM - edited 12-30-2021 01:15 PM
Hello @abdullah.al.sipon @Georg Pauwen
From looking at your current lap simulation setup and the VLSM table you have been provided, you need to readdress your topology correctly as presently it is incorrect.
Clue -
You have 6 /30 networks (L-1 to L-6) and to connect all your city rtrs together requires 6 interconnections
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2021 10:18 PM
@paul driver The VLSM table is randomly generated and I can update it as per my likings..
But to connect the sub networks to Gotham, which routers do I need to connect with it?
