Connecting two Routers using E1

[Kaushik Ray]

Hello I intend to connect up to routers back to back using E1.

I am about to prepare a cable for that.

I have found that the adviced cable for it is as below: can someone confirm this is correct please?

Many Thanks in advance.

Regards

Kaushik

[paolo bevilacqua · Accepted solution]

No. E1/T1 cable uses only 4 pins, that is, two pairs.

[Kaushik Ray]

Thanks Paolo

Do you have a link for the pinouts which I could refer to please?

[Kaushik Ray]

The interface is

VWIC3-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1

[Kaushik Ray]

Paolo

Did you mean to say the following? I think the first drawing essentialy shows the same pinout?

[paolo bevilacqua]

Yes. But use two pairs only.

Thanks for the nice rating and good luck!