- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2008 04:32 AM - edited 03-04-2019 12:10 AM
hi,
when i tried to delete vlan.dat file i got the following messange.
%Error deleting cat4000_flash:cat4000_flash:vlan.dat (Permission denied)
what might be the problem.
Solved! Go to Solution.
- Labels:
-
LAN Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2008 07:46 AM
Hi,
have you tried
"erase cat4000_flash: " command as advised by the link you received from Francisco1?
BR,
Milan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2008 04:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2008 04:45 AM
i have read the above article , the problem is that when i issue the command "delete cat4000_flash:vlan.dat" it gives the following message.
%Error deleting cat4000_flash:vlan.dat (Permission denied)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2008 11:03 PM
please need help in deleting vlan.dat from 4948 switch.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2008 07:46 AM
Hi,
have you tried
"erase cat4000_flash: " command as advised by the link you received from Francisco1?
BR,
Milan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2008 10:19 PM
Thanks for your reply, it works :) ,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-14-2020 12:32 AM
dont apply erase erase comand it will be a disaster. it erase ur flash file also

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2016 09:27 AM
Hello Everyone,
Could you help me ?? I tried the same command: "erase cat4000_flash:" after reload the switch starts on "rommon mode" ! Thanks so much !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2023 10:02 AM
just reboot and put the command: boot system flash bootflash:cat4500-entservicesk9-mz.150-2.SG11.bin
bootflash:cat4500-entservicesk9-mz.150-2.SG11.bin its your IOS, maybe in your sw its other
