I have a 2911 that will be using a 4G wireless card. It seems that it'll need to get a DHCP address from Verizon (even though we requested a static). I'm trying to configure the cellular interface to get the DHCP address using the "ip add dhcp" command, but it's not valid.
We're running IOS version 15.2(3)T1 on this guy. Does that need to be upgraded for this command to be available?
Yes - the command "ip address negotiated" does work and it's currently in the running config.
EDIT: I'm not sure what you mean by whether or not the command "works", but it's an option to be configured on the interface and it's saved in the running config for that interface. The interface status is:
Router#sh int cell0/3/0
Cellular0/3/0 is up (spoofing), line protocol is up (spoofing)
Hardware is 4G WWAN EHWIC - Verizon Multimode LTE/eHRPD/EVDO RevA/Rev0/1xRTT
Internet address will be assigned dynamically by the network
Hi Guys, I have two questions about EIGRP behavior when we have Multiple EIGRP routes: 1- I tried to show on some router the acquired EIGRP paths for a route X.X.X.X by typing the command : "show ip eigrp topology X.X.X.X". On the output there w...
[ The Discussion forum will be published on December 1st ]
Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...