Router @ Remote site (flash:c2800nm-spservicesk9-mz.123-8.T8.bin") and MS-DHCP server at central site
currently helper address at remote points back to central to pull address
But I want remote router to act as dhcp server for voip phones and have
helper-address only on data vlan back to central below is snapshot of current
configs
interface GigabitEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$
no ip address
duplex auto
speed auto
!
interface GigabitEthernet0/0.11
description Corporate Systems
encapsulation dot1Q 11
ip address 10.5.11.1 255.255.254.0
ip helper-address 10.1.2.30
service-policy output BRANCH-LAN-EDGE-OUT
!
interface GigabitEthernet0/0.131
description $FW_INSIDE$
encapsulation dot1Q 131
ip address 10.5.131.1 255.255.255.0
ip helper-address 10.1.2.30
service-policy output BRANCH-LAN-EDGE-OUT
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
Only 11 and 131 has helper-address. I want to keep helper on 11 but take out
helper on 131 and make router a dhcp server. Can I do this or will the router
process dhcp differently? How does the router process dhcp process in this
scenario?
Thanks