Routing

We are in the midst of implementiing the BGP system for our internet access. Currently we have 2 upstream providers connecting to the router (1xE3 & 1xFE) and is running on static IPs.We are adding another upstream provider for our BGP connection. (W...

Hello,I installed NM-18DM in the Cisco 3640. The customer told me that sometimes the remote users can't connecte to the site, so the administrator must reboot the router to resolve the problem.Another problem, there? is no server log to analyse what ...

HIWhat does it mean Technicaly "assymetric routing "10xs

helloI give two services from my providerand I am using tunnel interface,because of two service I need to have two tunnel with same source address,and its not possible,,any solution for this ?note that redundancy is an important issue.regards

What is concept when you need to implement both command? please clarify.TIA

I'm looking for a 100/1000 48 port switch with a GBIC SFP module for the uplink... Any recommendations on a particular model. I don't need it to do any sort of vlans or routing.Thanks!

I am getting redistribution EIGRP->ISIS just fine. However, I noticed the following. Can someone clarify:RouterB(EIGRP 100)s0:152.1.1.1/24LO:1.1.1.1/24connected V.35 toS0/0:152.1.1.2/24RouterAe0/0:3.3.3.4/24LO:4.4.4.4/24(running ISIS and EIGRP 100)co...

Hi,Hoping that some experts in network design will help out here. The scenario is this. We have approx 150 servers that we want to move to a data center. Each server will be dual homed. There is a possibility that iLO (LOM) will also be used alth...

Hi , I have a 12k router connected via 1 GB Fiber to another which refuses to form ISIS adjancency. The Process gets stuck in the INIT state. I do however notice the reliability on the interface is like 200/255. We have changed fiber leads,cards on t...

Hi Alli use Cisco router together with someJuniper router. During maintenance time iuse the "set protocol ospf overload" inJuniper to turn off traffic. It exists asimilar command in Cisco IOS (avoiding tu put a high OSPF cost on each interface) ?

Hi Sir,I have few routers on OSPF Area 0. Currently no OSPF authentication is configured.I'm going to enable OSPF MD5 authentication on only a few routers and selected interfaces only, with the following interface config commands:ip ospf authenticati...

hello,I want to configure MULTI LINK PPP for my two ADSL connection... i have two different ISP connection of ADSL and both the ISP had provided me their ADSL router... now from ISP router i have two ethernet cable to use internet for my user... now ...

How to fix {Slips, Errored Seconds, Severely Errored Seconds, Line Code Violations & Path Code Violations} for E1/T1 IMA bundles.I've been reading quite some documentation on this topic but such mainly refers to either "checking the clocking on the l...

Hi,I have a question about RIP routing:I have 2 routers (A and B) connected to each other via an ATM wan link.Each router has several routes in his routingtable. For example: router A has a route to 10.0.0.0/16, 10.0.1.0/24, 10.0.2.0/24,...Router A h...