11-18-2015 05:42 AM - edited 03-05-2019 02:46 AM
Hello
I have a dual Hub running and i want to activate HSRP. When i change the config the server cannot connect any pc over the VPN of the router.
Why? If i deactivate it the router can connect the pc. i think the HSRP cannot connect to the VPN´s from the DMVPN on the 2 Hub.
Did anyone know how to configure this?
Thanks
11-22-2015 11:26 AM
When using HSRP, the hub tunnel's source address is usually the HSRP address. Whichever router is the master master will have its tunnel up, and the other will have its tunnel down.
The inside of the hub routers will also need a dynamic routing protocol.
However, it is often easier to just run both hubs hot rather than active/standby ...
11-25-2015 12:16 AM
Hello
I found the problem. i copy the config in my lab and testet it. the tunnels are always up but my provider blocked the ipsec and so the tunnel didn`t come up.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide