cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
217
Views
0
Helpful
1
Replies

e1 pri card to create diff channels

dear all below given is my router sh version.

------------------ show version ------------------

Cisco IOS Software, C2600 Software (C2600-IPBASE-M), Version 12.4(10a), RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Compiled Wed 11-Oct-06 18:15 by prod_rel_team

ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)

Ghubra-Router uptime is 0 minutes

System returned to ROM by power-on

System image file is "flash:c2600-ipbase-mz.124-10a.bin"

Cisco 2611XM (MPC860P) processor (revision 4.1) with 127308K/3764K bytes of memory.

Processor board ID FCZ104472KN

M860 processor: part number 5, mask 2

2 FastEthernet interfaces

32K bytes of NVRAM.

32768K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

will this router work with 1 port e1 card female serial type ,i dont have the part no of the card, im planning buy one.

my requirement is to buy the card where i can make 30 diff channels.

VWIC-2MFT and VWIC2-2MFT 2nd gen cards wont allow to create more than 2 channels.if u know the part no of the card pls share it.

Regards

Binoy.

1 Reply 1

carenas123
Level 5
Level 5

Yes, it will work and also please don't forget to update your IOS

Review Cisco Networking for a $25 gift card