cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
342
Views
0
Helpful
1
Replies

Eigrp Delay Commands in interface...

Dear All/Akash Agrawal,

 

Actually I am testing failover in eigrp with GNS3  , After configured the Delay (interface gi0/0 , delay 2) still traffic is going via and gi0/0 instead of gi0/1.

Can you guide for the above  issue.

 

Best regards

Debadurlav Sarangi.

1 Reply 1

Hello

 

Can you post the config and a brifef topology diagram

also:

sh ip eigrp topology
sh ip route eigrp

res

Paul


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul