Routing

I have a default route already configured manually in my routing table, let's say that I have a new BGP connectivity and they start advertising default route instead of whole vrf routes. what would be the behaviour of routing now that I have 2 defaul...

Hi allwe have two point2point link as a media between our side and another customer side. isp one - 4mbps link and isp2 - 100mbps linkin our side configuration :-int gi0/1ip add 192.168.111.205descr one ispint gi0/2ip add 192.168.111.210descr second ...

Is it possible to have 1 ISP connected to the Primary ASA and another ISP to the Secondary ASA? Both connections will be active but if one ISP is to fail, all traffic would failover to the active ISP. Can this be accomplished in an Active/Active stat...

Anyone have any additional insight to this error message?%NHRP-3-PAKERROR: Receive Error Indication for our Error Indication, code: protocol generic error(7), offset: 0, data: 00 01 08 00 00 00 00 00 00 FF 00 48 7C 73 00 34I google'd and the only thi...

Hello,I am no expert in Cisco but definitely did not have problems in the past. So I have here a Cisco 891 which needs to be configured and I cannot see how. The sdm wont work like the old days, the ccp simply stucks or keeps giving errors. I would b...

Hi,From site a I can't ping Site B router 3(10.34.63.59) but I can ping R2 of site B switch and workstation.Details:from Site A R1IP Route  10.0.0.0/8 is variably subnetted, 7 subnets, 4 masksC       10.34.34.0/30 is directly connected, Tunnel3C     ...

Hello  , I need some support in setting netflow in my 7600 Cisco router ,  I had specific trafic comes to my router  with identified ip-src and ip-dst , but I can't expect from which interfaces it comes , How can I configure netflow in global router ...

I have 2911 router with two P2P 10 mbps Ethernet link, which want to club for effective 20 mbps bandwidth.any one can help how to do this like multilink system. 

Dear all,ip verify unicast source reachable-via  rx command gives the following error on cisco 3750x-24 L3 switch when configured on a routed port:- % ip verify configuration not supported on interface Gi2/0/24 - verification not supported by hardwar...

Hi Masters, Forgive me, I am a self learner. Now studying basic frame relay multipoint.I have done configure hub (R1) and spoke routers (R2 and R3) but I am confuse of how to configure the frame relay router (R4) in this hub and spoke situation. Can ...

Hi,I have a network setup with one Nexus 7000 at the Primary and the other at the DR. I have setup otv over a layer 3 point-to-point link between the two sites. Recently a second point-to-point link was provisioned be a different service provider. Ho...