Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As both trust-key are using the MD5 encryption. what is major Between NTP trust key 1 and Trust key 12. have tried to use the trust key 12 instead of trust key 1. but I could not see that NTP SYN.
Hi All,
Need a your help for below points.
* While login to Cisco WLC vai CLI it's pormoting for username for sconds times even though we are given correct username. Why is it?
Regards
Hi Team,
Need a small help from you.
We are able to ping server IP from Router but not able trace the Server IPs from router.
whenever we are tracing to Server IPs getting drops of that server default gateway.
Is that any configuration issue ?
Hi Team,
I have added more than 3 WLC (model no :5505) in cisco prime 3.1 but one WLC is showing that "partial collection failure".
Before adding to Cisco prime, done the SNMP Verification that was showing successfully but still status showing "par...
Hi Team,
Could you help me to configure the EIGRP for Internet traffic as well as intranet traffic in single Router .
Requirements are given below.
1.We have one MPLS link which is connect to HQ and One internet link ..
2.Both links are connected ...
Hi Richard,
I am really appreciated with you and showing interested to troubleshooting issues.After removed the "no ip unreachable" command for L3 interface from Switch.it is working fine in my lab.
Thank you gpauwen and others. you resolved my is...
Hi Lohit,
PBR neither configured on Destination end nor Source end.
If i will do the trace route from CMD it is happening . but not from router/ switch.
Regards
Deb
Hi mark,
Thanks for your reply.
Last Hop - Distribution Switch.
Trace is dropping from DB switch. Server is connected in a access switch which is connected to same DB Switch.
For Your reference- i.We are able to reach destination network DB switch....
As i understood, U want to configure the Primary and Secondary dns in your ISR router.
If yes, please try below commands to configre it.
ip name-server server-address1 server-address2
