Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
836
Views
0
Helpful
2
Replies

eigrp hub and spoke question

pamirian76
Level 1
Level 1

‎08-31-2012 07:48 AM - edited ‎03-04-2019 05:26 PM

hi,

I,m working with gns3 to setup a test environment.

3 routers, 2 of them are hubs and the last one is a spoke.

with the 2 routers I'm just giving a default route to my spoke which is also just a stub router. then the stub is simply pushing to the hubs a summary.

now what I would like to do with the hubs is decide if on the spoke tunnel0 or tunnel1 gets used. right now they both have the same priority but I would like to be able with the hubs to make that decision.

so basically on hub I change something and it makes spoke #24 use tunnel 0 to hub 1 instead of tunnel 1 to hub 2.

hope I,m clear

also if possible please give me an example.

thanks.                  

Labels:
0 Helpful
2 Replies 2

dslice
Level 1
Level 1

‎09-01-2012 03:01 PM

now what I would like to do with the hubs is decide if on the spoke tunnel0 or tunnel1 gets used. right now they both have the same priority but I would like to be able with the hubs to make that decision.

so basically on hub I change something and it makes spoke #24 use tunnel 0 to hub 1 instead of tunnel 1 to hub 2.

###ds How are sending the default from hub to spoke? Summaries? Redistributed locally? Propagated from elsewhere?

Sent from Cisco Technical Support iPad App

0 Helpful

Lee Shouse
Level 1
Level 1

‎09-03-2012 12:55 AM

Have you tried changing the delay on your tunnel interfaces to make one route look better than the other?

Sent from Cisco Technical Support iPad App

0 Helpful
Customers Also Viewed These Support Documents