cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
375
Views
0
Helpful
2
Replies

eigrp-neighbor issue

seegomaa
Level 1
Level 1

dears

i have two cisco 1751 routers connected by isdn using EIGRP . The problem is no neighborship established between them and so eigrp not working

here is sample of show ip eigrp neighbor

H Address Interface Hold uptime SRTT RTO Q Seq

(sec) Cnt Num

0 20.0.0.81 bri0/0 14 00:01:17 1 5000 1 0

here is also part of debug eigrp neighbors command

%dual-5-NBRCHANGE: IP-EIGRP(0) 1: Neighbor 20.0.0.81 (bri0/0) is down: retry limit exceeded

note : no physical problem in the line (crc,frame,...) and i issued successfull ping from both sides with datagram 100 and 1500 .

2 Replies 2

ttuncaral
Level 1
Level 1

could you provide Bri config statements on both sides and SHOW INTERFACE BRI 0/0 outputs?

ttuncaral
Level 1
Level 1

could you provide Bri config statements on both sides and SHOW INTERFACE BRI 0/0 outputs?

Review Cisco Networking for a $25 gift card