Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have multiple WLC installations on different sites with Local APs. Is there a methodology or plan to solve fallback situation by installing a central WLC in the DataCenter (e.g.) What should I follow to create a solution to this problem? Licensi...
Hi,We are planning to use ONS with EMC in order for replicating disk storage asynchronously to a remote location. Estimated bandwidth requirement is 240Mbps and I think that this can be possible by using 2xOC3 link from our telco provider. Is there a...
I have a server which is located inside interface a two layer firewalled intranet of a large corporate network. I would like to make this server accessible from Internet. What would be the best practice on providing public access to a intranet server...
I installed a 2Gb/s etherchannel link between 6509 and Nortel Passport 8610. Nortel works for L3 switching and 6509 only for L2 as a distribution layer backbone. Also 6509 use 2 MST instances. There is a dhcp-server behind a firewall which is connect...
doea anyone have any experience etherchannel trunking Cisco Catalysts with Nortel Passport 8610? I created an etherchannel trunk between a 2950 and a Passport 8610 thru GigE interfaces. Port channel becomes UP but after 30-40 seconds it goes down wit...
Can I configure APs at remote sites as Remote APs of Central Site in the fallback situation? The only need is to take control at central location if remote WLC fails.
Are you looking for a tool for converting CatOS configuration lines to IOS configuration lines or a tool to convert CatOS switch to IOS (native) switch?I know that converting switch is a manual process which can be done by booting ROMMON.I can provid...
I am not sure that your problem is solved or not. I had the same problem one month ago between Nortel 8600(MLT) and cisco 2950(FastEC). Nortel tech provides us a procedure which describes step-by-step configuration with MLT and etherchannel on these ...
finally, this problem was closed by this way.This is having some specific configuration steps on both sides. Passport configuration must be done first and Cisco later. Link must not be connected until whole config has been completed. STP must be disa...
The only working LACP option between those switches is MODE ON on catalyst side. Other two options do not work. I want to find why the etherchannel became up and after a short period of time went down. I also work with Nortel tech support in order to...
