hi, I have a question I cannot figure out. I ran this sho ip eigrp top command and the originating IP address is no where on my network that I can find. I looked at CDP neighbors, pings don't answer, traceroute doesn't turn up anything. Any thoughts where that IP came from?
sho ip eigrp top 126.96.36.199 255.255.255.0
EIGRP-IPv4 Topology Entry for AS(1)/ID(192.168.31.1) for 188.8.131.52/24
State is Passive, Query origin flag is 1, 1 Successor(s), FD is 2816
0.0.0.0 (Vlan19), from Connected, Send flag is 0x0
The field for originating router is based on the router ID of the router that originated the advertisement. I was about to suggest that someone had configured the router ID for their EIGRP process and perhaps had fat fingered the address and that might be difficult to find the router. Then I noticed these lines of output
Hop count is 0
Originating router is 192.168.31.1
If the hop count is zero then it appears that the advertisement originated on your router. So would you please post the output of the command
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...