08-19-2011 03:33 AM - edited 03-04-2019 01:19 PM
Hi ,
Interfaces with encapsulation HDLC and found no CRCs and input errors. But when we configured with encapsulation PPP then started getting CRCs and input errors.
I am serching for the reason , Appriciate if any one help here .
===========
thanks
08-21-2011 09:30 AM
.Which interface is causing errors.
could you please post entire
"sh run"
:sh interface sex/y/z
~Jyoti
08-21-2011 09:37 AM
Jyoti,
sh interface sex/y/z
Hmm... does Cisco install one of those already on its routers?
Best regards,
Peter
08-21-2011 10:29 AM
Hello,
CRC and input errors have no relations with the encapsulation method on Serial interfaces. I doubt you have seen it with PPP rather than HDLC.
However, if you still see it, then it would probably be some problem with the Telco, I would say you need to ask your provider for a Loop test if possible on the WAN link.
Regards,
Mohamed
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: