Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1928
Views
0
Helpful
1
Replies

ENTITY_ALARM-6-INFO

jtalbaugh
Level 1
Level 1

‎09-26-2008 05:51 AM - edited ‎03-03-2019 11:42 PM

Getting the following error on Cisco 7206VXR w/ IOS c7200-adventerprisek9-mz.124-9.T7.bin

Sep 26 08:43:57: %ENTITY_ALARM-6-INFO: ASSERT MAJOR Se2/0 Receiver has remote alarm

Sep 26 08:43:58: %ENTITY_ALARM-6-INFO: CLEAR MAJOR Se2/0 Receiver has remote alarm

Any suggestions would be appreciated and I will provide any additional information as needed.

Added: The interface is flapping.

1 person had this problem
Labels:
0 Helpful
1 Reply 1

mvsheik123
Level 7
Level 7

‎09-26-2008 06:05 AM

Hi,

most likely this is because of circuit issue with carrier. Your circuit is flapping. If you run 'Sh int ser2/0' then you can oserve increasing 'Carrier transitions'. Call the carrier and ask them to resolve the circuit issue.

HTH

MS

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card