Failed to add port channel on Cisco indestrial Switch

mrkhalid40080743 · ‎11-16-2020

PLease Can any Body help me !!!

% Command Rejected: Remove ACL configured on member port
GigabitEthernet1/1 is not added to port channel

marce1000 · ‎11-16-2020

- Check/show-us the running-config of this port first.

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Georg Pauwen · ‎11-17-2020

Hello,

I would default the member ports and try again:

Switch(config)#default interface x --> do that for all member ports

paul driver · ‎11-18-2020

Hello
If this is a production PC then I wouldn’t suggest you default any physical interfaces that are part of the etherchannel, you should in theory be able just to add an additional physical interface to a existing PC unless its not configuration the same as the other members ports.

So make sure the physical interface your adding has parity with the other PC members in terms of configuration.

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul