cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
562
Views
0
Helpful
2
Replies

Flexconfig EIGRP setup on Sourcefire 2130

0rsnaric
Beginner
Beginner

Does anybody have a configuration example for setting up EIGRP on the Sourcefire 2130? Preferably via FDM, and not FMC.


All of the Cisco docs I have found just go over generic flexconfig setups. Nothing specific to EIGRP.

 

Thanks!

 

 

1 Accepted Solution

Accepted Solutions

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

i was not used FDM for Long we use most of time only FMC

 

but as per document :

 

EIGRP

FlexConfig

Configure EIGRP using FlexConfig objects from the Device > Advanced Configuration page.

 

 

check if that works

 

https://www.cisco.com/c/en/us/td/docs/security/firepower/660/fdm/fptd-fdm-config-guide-660/fptd-fdm-routing.html

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

2 Replies 2

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

i was not used FDM for Long we use most of time only FMC

 

but as per document :

 

EIGRP

FlexConfig

Configure EIGRP using FlexConfig objects from the Device > Advanced Configuration page.

 

 

check if that works

 

https://www.cisco.com/c/en/us/td/docs/security/firepower/660/fdm/fptd-fdm-config-guide-660/fptd-fdm-routing.html

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Thank you.

This ended up being nothing more than a typical eigrp setup reduced to variables and templates.

No idea why they are pushing template based networking to smaller shops. I have no need to deploy this config to multiple devices...just one.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers