04-08-2015 08:39 PM - edited 03-05-2019 01:11 AM
Hello
I tried to configure netflow in a ISR4451, but in solar winds I have this error: "details for interface gi0/0/0 on router-test are not available because netflow and CBQos data are not available.
This is the configuration:
flow record v4_r1
match ipv4 tos
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
collect counter bytes long
collect counter packets long
!
!
flow exporter EXPO1
destination x.x.x.x
transport udp 90
!
!
flow monitor FLOWMON1
exporter EXPO1
record v4_r1
!
!
interface GigabitEthernet0/0/0
ip address y.y.y.y z.z.z.z
ip flow monitor FLOWMON1 input
ip flow monitor FLOWMON1 output
!
What am I missing?.
Thanks
04-09-2015 12:26 AM
04-09-2015 09:37 AM
Hello Milan, thanks for the reply.
the match interface output/input to my flow record is the gi0/0/0 witch I had this commands:
ip flow monitor FLOWMON1 input
ip flow monitor FLOWMON1 output
is that what are you refering?.
Yes, our collector is configured to receive NetFlow on UDP port 90.
Thanks!.
04-09-2015 10:18 AM
Hi,
no, what I meant was
flow record v4_r1
...
match interface input
in your config.
But as I said, I'd recommend to use
flow monitor FLOWMON1
record netflow ipv4 original-input
instead of your customized record.
Best regards,
Milan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide