frame-relay with ospf not working

[slimgrim]

hi everyone i have a problem i configued 3 router with frame-relay ietf with ansi lmi

but they don't ping each other  ,you'll find the commands in a text file and  a screenshot  bellow

[Georg Pauwen]

Hello,

post your zipped Packet Tracer project (.pkt) file...

[slimgrim]

Done you can check it

[Georg Pauwen]

Hello,

there were several mistakes in your config:

--> ANSI type on the cloud was set to cisco (default)

--> several area mismatches in your OSPF config

--> network 192.168.1.0/24 advertised on all routers (non-existing network)

--> missing mappings and neighbor commands (assuming that what you want is a full mesh)

Attached the revised file(saved in PT version 8.1). It takes a while for OSPF to converge (several minutes).

[balaji.bandi]

First, you need to have sub interface reach each other before OSPF can form the  relation :

check below example: make necessary IP changes to form OSPF peering and reachability.

http://www.orbit-computer-solutions.com/how-to-configure-frame-relay-subinterfaces/

DLC mapping also look below example :

https://ccieblog.co.uk/ospf/ospf-point-to-multipoint-network