02-02-2022 01:01 PM - edited 02-02-2022 02:30 PM
hi everyone i have a problem i configued 3 router with frame-relay ietf with ansi lmi
but they don't ping each other ,you'll find the commands in a text file and a screenshot bellow
02-02-2022 01:19 PM
Hello,
post your zipped Packet Tracer project (.pkt) file...
02-02-2022 02:31 PM
Done you can check it
02-03-2022 01:07 AM
Hello,
there were several mistakes in your config:
--> ANSI type on the cloud was set to cisco (default)
--> several area mismatches in your OSPF config
--> network 192.168.1.0/24 advertised on all routers (non-existing network)
--> missing mappings and neighbor commands (assuming that what you want is a full mesh)
Attached the revised file(saved in PT version 8.1). It takes a while for OSPF to converge (several minutes).
02-02-2022 01:47 PM
First, you need to have sub interface reach each other before OSPF can form the relation :
check below example: make necessary IP changes to form OSPF peering and reachability.
http://www.orbit-computer-solutions.com/how-to-configure-frame-relay-subinterfaces/
DLC mapping also look below example :
https://ccieblog.co.uk/ospf/ospf-point-to-multipoint-network
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide