Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
409
Views
0
Helpful
2
Replies

GLBP not load sharing. OSPF is enabled

chris
Level 1
Level 1

‎07-28-2005 10:37 AM - edited ‎03-03-2019 10:09 AM

I have GLBP running on 2 point-to-point T1s with a total of 4 routers, 2 on each end. It appears OSPF is not allowing the GLBP to load share because all traffic is going over 1 connection. How do you configure the routers to load share with OSPF enabled?

Labels:
0 Helpful
2 Replies 2

chris
Level 1
Level 1

‎07-28-2005 10:50 AM

Problem is resolved. It was an OSPF area problem. One serial interface was not in the OSPF area.

0 Helpful

dgahm
Level 8
Level 8
In response to chris

‎07-28-2005 02:55 PM

FWIW, GLBP allows hosts on a LAN to load balance outbound between 2 default gateway routers. GLBP has no influence on routing protocol load balancing over serial links.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card