How do determine which pc's are using up the wan bandwidth ?

[anand.narine1]

Please see the attached screenshot., how do i go about this?

[vmiller]

start here:

http://www.cisco.com/en/US/docs/ios/fnetflow/configuration/guide/cgf-topn.html

[anand.narine1]

Suppose I have:

  Clients -------- switch-------router--------router----------router (netflow enabled) ---------switch---------Servers

In  the above topology with netflow only enbled in the last router. Will i  still be able to monitor which clients are using up bandwidth to the  Servers? Or should I enable netflow on the first router?

[vmiller · Accepted solution]

i would go closest to the source of the traffic. So, Router 1 at the client side.

[serge123]

You could configure under the interface

Show ip accounting to check the result