Routing

Morning,Guys I have a VLAN that is totally slow on the internet, I am not sure if is contributed to the power outage that we last Friday night, but I notice the issue Monday morning. I checked everything I can possible check with the core switch, I h...

Hello, I have to add a bgp peer on router Cisco 7206 VXR NPE-G1 and the ASN is 199393, anyway the router allows <1-65535> range number of ASN,How can I add the ASN on my router? Kind Regards,Ardit

Hi, guys! I'm experiencing problems with NHRP in redundunt DMVPN topology. I'll try to describe the issue:We have three routers: 1 hub and 2 spokesHub have two links to different ISPs, spokes have one link. I created two tunnel interfaces on hub and ...

I have two PXM1E cards one is slot 7 and the other in slot 8 that my company recently purchased used, and they are both doing the same thing.This is what I am seeing when the unit is booting up."Unable to determine size of C:/FW/pxm1e_003.000.023.202...

Hi all,The following  log message is observed on 4507 swicth running IOS : cat4500-entservicesk9-mz.122-54.SG1. I am aware that this is a multicast packet which is invalid and no learning is done. This is wasting my cpu resources.Wiuld like to know h...

Hi All,I'm currently learning about GLBP. I have 6 routers as part of a GLBP group. The reason that I have six (I know it's a bit too much) as I was trying to proove a theory.So far 4 of the routers are acting as 1 AVG (R1 ) and 3 AVF (R2, R3, R4) an...

Hello,I am trying to confiure Layer 3 port channel between 6006  and cisco 4503 switch. Existing connection between them is a layer 3 link with IP address and VRF configured.Can I move the VRF and IP address on to the Port-channel interface and hope ...

I am trying to setup my lab so that I can have internet access.  I am having a little problem configuring my router to allow it.Here is what I have going on:Dlink Router connected to the Internet ModemCisco 2821 connect to LAN port on back of Dlink R...

I'm very new to router configurations. I have a 891 router in a remote office that is setup with EZ VPN back to my ASA 5512x firewall. The connection at the remote office is a DSL line and in the past it has had infrequent problems where the EZ VPN c...

Hey all, Having a bit of an issue with bridge-domains on ASR 1001 and dynamic ARP entries. Looking through the packet captures, I see the following events DHCP request from CPE DHCP ACK and assignment from DHCP server to CPEGratuitous ARP sent from...

HalloI'm trying to summarise 192.168.0.0 /24 and 192.168.1.0 /24 routes (it's only an example) -imagine severall routers and the "last" one schould only "see" the summary route - therefore I use the commandR1(config-if)# ip summary-address rip 192.16...