05-16-2011 06:00 AM - edited 03-04-2019 12:24 PM
Does anybody know how to configure a
Cisco 857 on adsl for kingston comms in Hull United kingdom
it has a dynamic peer
we cannot get connectivity with the adsl (NO PPP Light)
Kingston have proved that the adsl is active on the phoneline
10-11-2011 02:13 AM
Hi,
Are you terminating the link on ATM interface ??
If yes, can you post the output of command
sh dsl int atm
sh caller
debug ppp negotiation
debug ppp authentication
sh run int dialer
sh run int atm
10-11-2011 09:37 AM
I was in Kinston last week setting up routers at several sites. We initially found the same issue.
Kingston/Hull is an odd area all unto itself.
Change the PCV to 1/50 :
establish a PPP session in accordance with RFC 1661 [15].
support PPPoA or PPPoE as defined in section 5 above
support Challenge Handshake Authentication Protocol (CHAP) in accordance with RFC 1994 [16]
obtain an IP address
use ATM VPI/VCI 1/50 for data transmission/reception
carry out upstream traffic shaping to the ATM rate
Hope this helps
Simon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide