Hi all,
I was looking through my 1100 Series ISR data sheet and Software Configuration Guide to find the commands / config examples for carrier aggregation that should be supported by this hardware. Unfortunately, I was unable to find info on how to configure this. I would like to configure aggregation between band 3+(7,20) stated as supported in the datasheet. My understanding is that this is an aggregation between band 3 (1800MHz) + band 7 (2600MHz) or band 20 (800MHz)
[EDIT] Found this Network Interface Module Configuration guide for the ISR 4000 series. It mentions band aggregation as well but again no configuration examples or CLI commands that give any info on where to start.
Would highly appreciate any information on this.
