I'm trying to configure two NCS-5501's running IOS-XR with a QinQ interface for a customer on each end. Apologies if I'm getting my Encaps types wrong, but essentially we are tagging any traffic from the customer with VLAN200 internally. I've been l...
Migration Using Cisco Catalyst SD-WAN Manager (formerly Cisco vManage) Note1: Specific requirements:Cisco vManage Release 20.4.1 or later•Cisco Integrated Services Routers (ISR)1100 and ISR1100X Release 20.4.1 or later• Note 2: Migration between Vipt...
Hello all, i have some standalone routers (1100-4G)that i have been asked to install VIPTELLA 20.3.3 onto They are currently running IOS XE SDWAN isr1100be 17.4.1a Having looked all morning but without any luck, is there any documentation on how to a...
i try to install it on kali but this error still exist The following packages have unmet dependencies: packettracer: Depends: libgl1-mesa-glx but it is not installable
This is a weird one, to me at least, asked some other people internally and none of us have figured it out so far, so outsourcing to you wonderful folk. We have a series of switches that are all connected in an MDF, one core switch and two access swi...
Ive just booted a new ISR4431 router. Its running IOS 17.5. It tells me it is in "Controller Mode". How do i make it go to plain ordinary router mode?
Hi.We are seeing a high CPU load on the router (Cisco 2921). All other problems are a consequence of this.At the same time, there is only one high-load process in the show proc cpu command output:CPU utilization for five seconds: 99%/47%; one minute:...
HiI have two routers: A---B.Router B is redistributing static route with redistribute static command. This means that it uses the bandwidth and delay of the interface from which it is sending advertisement as seed metric. This seed metric is in class...
I have attached plain and simple configurations. I was replicating a topology from ENCOR 350-401 from Kevin Wallace regarding the different LSA. I used a NetSIM for the simulation. I have attached the configuration and topology diagram (Kevin Wallace...
Hi, we need to plan to buy catalyst 8000 series routers, but seems they are not in CCW portal. Last year I still can create an estimate for 8200 router, but this year it is not available. Don't know why. Can someone please advise where can create an...
I tried to run test radius command but I get below log in ASR9904The executable 'test_radius' can not be launched. Error: 'libovl' detected the 'fatal' condition 'No such file or directory'
Our small-business router is experiencing significant amounts of downtime. We did the following to sort out the issue such as:-monitor network traffic-check for overheating-reboot the device-check for firmware updatesAnd so far, it does not seem like...
Hello, everyone When a router forwards a REGISTER message to the RP, it will include the multicast stream. If a register-stop message is received, the further registers are sent without the multicast stream, only the IP header My question is, why i...
Hello, everyone. When configuring Multicast, I often see the Source-Based tree called the Shortest-Path tree. It's basically the tree where the multicast sender (or the FHR connected to it) is the root of the tree and it involves the shortest/best pa...
Routing is the backbone of any network, guiding data packets to their correct destinations. Among the many routing strategies, the default route is a simple yet powerful solution. It streamlines network configurations and efficiently manages traffic,...
