How to configure IP SLA for failover in Cisco 1841?

[deepthirajt]

Should I configure a IP SLA responder?

If yes, How can I do that?

[Bharat Sharma]

Hi Georg,

Thanks for support.

[Georg Pauwen]

Hello,

there is nothing configured on that interface on your backup router:

interface GigabitEthernet0/0/1
no ip address
shutdown
negotiation auto

What do you want to configure there ?

[Bharat Sharma]

Hi Georg,

Thanks...

[Georg Pauwen]

Hello,

[Bharat Sharma]

Hi George,

Thanks.

[Bharat Sharma]

Hi George,

We are planning to configure IPSec on both router same interface g0/0/1 after configuring IP SLA so some changes require in given IP SLA script.

Please Help... 

[Bharat Sharma]

Hi George,

I have configured IP SLA but while configuration timeout 500 & frequency 3 not accepting it's showing below error.

#Error: timeout is less tean threshold 5000

#Error: frequency is less than timeout 5000

so I have configur 5000 in both command. Kindly help to understand above error & let me know any changes require. 

timeout 5000
frequency 5000

[Georg Pauwen]

Hello,

I guess I forgot a zero. The values 5000/5000 are fine. Is the SLA working otherwise ?

[Bharat Sharma]

Hi George,

Thanks...

[Georg Pauwen]

Hello,

you are tracking two routes. Post the full configs of both routers. In the meantime, try to just use default routes:

ip route 0.0.0.0 0.0.0.0 10.221.203.13 track 1
ip route 0.0.0.0 0.0.0.0 10.221.1.38 10

[Bharat Sharma]

Hi Georg,

We have numbers of route which is pointing to deffrent gatway or interface.

If I add a default route so it will effect existing route communication?

[Georg Pauwen]

Post the full configs of your routers.

If you only have these two networks going out via 10.221.203.17, you can use a default route. Is there anything else going out via 10.221.203.17 ?

ip route 10.221.99.0 255.255.255.0 10.221.203.17 track 1
ip route 10.221.100.0 255.255.255.0 10.221.203.17 track 1

[Bharat Sharma]

Yes we have numbers of route.

Please check earlier post, I have uploaded both router configuration file. 

[Georg Pauwen]

Hello,

Post your current full configs...