How to enable 'show process cpu history table" feature?

[cciesec2011]

How does one go about enabling this feature below:

c3845#show process cpu history table
%CPU utilization history table is not enabled

c3845#

Thanks.

[Ganesh Hariharan]

How does one go about enabling this feature below:
c3845#show process cpu history table
%CPU utilization history table is not enabled
c3845#
Thanks.

Hi ,

Configure the following commandsin router !!

process cpu statistics limit entry-percentage number [size seconds]

Example:

Router(config)# process cpu statistics limit entry-percentage 40 size 300

Sets the process entry limit and the size of the history table for CPU utilization statistics.

•In this example, to generate an entry in the history table, a process must exceed 40 percent CPU utilization.

•In this example, the duration of time for which the most recent history is saved in the history table is 300 seconds.

Hope to help !!

Regards

Ganesh.H

[AJAZ NAWAZ]

Can you please provide a screenshot for the output from this command?

thank you

[Kevin Morales]

R1#  sh proc cpu history table

CPU utilization for five seconds: 0%/0% at 00:05:35

R1#