How to install G0/0/02 port on 4311 switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2022 02:27 AM
Hi All,
My assignment requires me to attach two routers one using a copper cross-over cabling.
I'm connecting router 2901 via int g0/0 to router 4311 via inter g0/0/2. However this port is not readily available?
Any suggestions on how to install this port on 4311 router?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2022 03:08 AM
Do you have access to the router?
show ip int br

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2022 03:21 AM
Hello,
I assume this is a Packet Tracer project, and you are talking about the the 4331/4321 routers ?
You need to do this:
Go to the 'Physical' tab, then select the GLC-T and insert it in the upper or lower right slot (there are 4 slots on the left where you can insert them.
This will enable the interface (see screenshot).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2022 03:39 AM
Hello
@bi13hy wrote:
connecting router 2901 via int g0/0 to router 4311 via inter g0/0/2. However this port is not readily available?
Can you elaborate on what you mean?
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2022 04:30 AM
Hi Paul,
I've managed to solve the issue.
Through adding additional hardware, NIM 2T and NIM ES2-4.
regards
