How to route 2 WAN IP-Addr into RV110W thru to 2 different servers

[EL Louie]

Hi:

Just purchased a Cisco RV110W for our small business.  We were told this was easy for us to use and secure enough for our small office and for our travelling sales staff to access our website.

We purchased 2 dedicated IP-addresses, 216.82.5.230 for access to one server, and 216.82.5.231 for access to a second server (these IP-Addresses given are just an example; not real). 

These come into the single RV110W WAN port.  The two servers are plugged into 2 of the 4 LAN ports. 

But the WAN setup page only accepts one WAN IP-Address.  So when we put in 216.82.5.230, the outside world can HTTPS into one server, but we don't know how to get them to HTTPS to the second server when the other staff uses 216.82.5.231.

In summary, can someone help us use the RV110W admin panel to forward the HTTPS/SSL traffic from 216.82.5.230 to one server (setup internally on 192.168.10.20), and the HTTPS/SSL traffic from 216.82.5.231 to the other server (setup internally on 192.168.20.20 using the VLAN setup on this router)?

Thank you for any help you can provide.

Regards,

E L

[paolo bevilacqua · Accepted solution]

Use Small Business forum. This is for true Cisco products.