Hi..
We are using HPUX server to collect files from switch to our server. Our server connect to cisco router and the cisco connect to X.25 protocol to communicate with switch. My question, how could i collect files from swicthes to our server and what is the command can i used ?.
This is some info about router.
'Serial0/0/0 is up, line protocol is up
Hardware is GT96K Serial
Description: LL018766
MTU 1500 bytes, BW 1544 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation X25, loopback not set
X.25 DTE, version 1984, address <none>, state R1, modulo 8, timer 0
Defaults: idle VC timeout 0
cisco encapsulation
input/output window sizes 7/7, packet sizes 128/128
Timers: T20 180, T21 200, T22 180, T23 180
Channels: Incoming-only none, Two-way 2-16, Outgoing-only none
RESTARTs 55/0 CALLs 0+0/0+0/0+0 DIAGs 0/0
LAPB DTE, state CONNECT, modulo 8, k 3, N1 12056, N2 20
T1 1600, T2 0, interface outage (partial T3) 0, T4 0
VS 2, VR 2, tx NR 2, Remote VR 2, Retransmissions 0
Queues: U/S frames 0, I frames 0, unack. 0, reTx 0
IFRAMEs 57/4 RNRs 0/0 REJs 0/0 SABM/Es 214018/44 FRMRs 20/0 DISCs 0/0
Last input never, output 1w2d, output hang never
Last clearing of "show interface" counters 1w6d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
Thank you