04-30-2013 08:27 AM - edited 03-04-2019 07:46 PM
I have installed VWIC-1MFT-G703 on Cisco 2811 with PVDM, but my question ->
For Cisco 2901, do I have to install PVDM to make VWIC3-2MFT-G703 available????
04-30-2013 09:03 AM
Hello Sirisak,
What type of circuit is this? Is this just for data?
Regards.
04-30-2013 09:06 AM
Thank you Jose, Yes, only data. Below is my configuration, is this correct?
CISCO2901/K9
CON-SNT-2901
S29UK9-15204M
SL-29-DATA-K9
2900-ZTD-CFG
VWIC3-2MFT-G703
PWR-2901-AC
CAB-AC
CAB-E1-RJ45BNC
PI-MSE-PRMO-INSRT
SL-29-IPB-K9
ISR-CCP-EXP
MEM-2900-512MB-DEF
MEM-CF-256MB
04-30-2013 09:12 AM
Hello Sirisak,
You do not need it. Probably the issue is that you do not see the serial interface. Is that the case?
Regards.
04-30-2013 09:15 AM
Yes, for Cisco 2811.
But I don't know that this case would happen with Cisco 2901???
04-30-2013 09:30 AM
Hello Sirisak,
Can you attach the "show run" of this new 2901?
Regards.
04-30-2013 09:34 AM
Sorry, Jose
I'm just doing the ordering (CCW), and I try to find the support document (but cannot find).
04-30-2013 10:17 AM
Hello Sirisak,
I have checked and I can see that if your circuit is not ISDN then you do not need the PVDM. There are 2 types of PVDM:
The Cisco® High-Density Packet Voice Digital Signal Processor (DSP) Module (PVDM2) enables Cisco Integrated Services Routers to provide high-density voice connectivity, conferencing, and transcoding capabilities in Cisco IP Communications solutions.
The Cisco 2800, 2900, 3800, and 3900 Series routers installed with the Cisco Digital Modem PVDMs offer dial access solutions with outstanding flexibility, scalability, manageability, and performance.
I hope this information can be useful for you.
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide