I have installed VWIC-1MFT-G703 on Cisco 2811 with PVDM

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 08:27 AM - edited 03-04-2019 07:46 PM
I have installed VWIC-1MFT-G703 on Cisco 2811 with PVDM, but my question ->
For Cisco 2901, do I have to install PVDM to make VWIC3-2MFT-G703 available????
- Labels:
-
Other Routing

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 09:03 AM
Hello Sirisak,
What type of circuit is this? Is this just for data?
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 09:06 AM
Thank you Jose, Yes, only data. Below is my configuration, is this correct?
CISCO2901/K9
CON-SNT-2901
S29UK9-15204M
SL-29-DATA-K9
2900-ZTD-CFG
VWIC3-2MFT-G703
PWR-2901-AC
CAB-AC
CAB-E1-RJ45BNC
PI-MSE-PRMO-INSRT
SL-29-IPB-K9
ISR-CCP-EXP
MEM-2900-512MB-DEF
MEM-CF-256MB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 09:12 AM
Hello Sirisak,
You do not need it. Probably the issue is that you do not see the serial interface. Is that the case?
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 09:15 AM
Yes, for Cisco 2811.
But I don't know that this case would happen with Cisco 2901???
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 09:30 AM
Hello Sirisak,
Can you attach the "show run" of this new 2901?
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 09:34 AM
Sorry, Jose
I'm just doing the ordering (CCW), and I try to find the support document (but cannot find).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2013 10:17 AM
Hello Sirisak,
I have checked and I can see that if your circuit is not ISDN then you do not need the PVDM. There are 2 types of PVDM:
- PVDM2-x
The Cisco® High-Density Packet Voice Digital Signal Processor (DSP) Module (PVDM2) enables Cisco Integrated Services Routers to provide high-density voice connectivity, conferencing, and transcoding capabilities in Cisco IP Communications solutions.
- PVDM2-xDM
The Cisco 2800, 2900, 3800, and 3900 Series routers installed with the Cisco Digital Modem PVDMs offer dial access solutions with outstanding flexibility, scalability, manageability, and performance.
I hope this information can be useful for you.
Regards.
