Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I'm trying to test our new firewall. I need to set the default route for my pc to be 10.1.1.2. The default route configured on the router is 10.1.1.1.I set up and access list with my permit host mypc any anyThen i created a route map: ip route-map te...

nkillgore by Level 1
  • 879 Views
  • 2 replies
  • 0 Helpful votes

Hi,I am looking for recommendation for BGP AS number design and would like to know the pros and cons of each of the option below.The setup is as below.I have 1 HQ office and several remote offices. All of these sites will have 2 routers each and all ...

glenn.lim by Level 1
  • 3217 Views
  • 7 replies
  • 0 Helpful votes

Hello,     I am using a Cisco 2610 as an internet router for my home office.  I've configured VPN on it so that I can tunnel traffic to it from outside.  I've been using is for years, works like a champ.  Now, I would like to change the ACL on the IS...

Hi, I have the below topology in my network I am planing to configure ospf in my network .Can any one confirm that how traffic will flow from B router to reach the networks behind the a router .with default ospf configurations .will it take the direc...

Good morning All,My company has a Cisco 3745 as our WAN router.  It is dying a slow painful death. Does anyone know what current product offering replaces the 3745?Thanks..                 

bsciarra1 by Level 1
  • 1059 Views
  • 2 replies
  • 0 Helpful votes

I'm buying a 2900 series router.  I need security (IPSEC VPNs), CME,CUBE and SRST.Which bundle should I buy?  I'm thinking VSEC-CUBE and add a line item for SRST?If I just ordered the UC bundle, what would I need to add?  A security license and CUBE/...

Hi All,I am trying to configure my cisco asa firewall . we have both 5505 and 5515.I know most of the commands but want to learn all funtionalities of the asa so have set the time aside to read through the document.so i went to read the following htt...

cisco8887 by Level 2
  • 396 Views
  • 2 replies
  • 0 Helpful votes

I´m facing a confuse problem. maybe the solution is simple but i can´t find it.the show policy map shows an offered rate far above the target shape rateshow policy-map interface tunnel 204 Tunnel204   Service-policy output: BA-DBNA-BRANCH-OUT-2M    C...

Hi.I've been asked to configure a C887VAGW router with a DSL service and a 3G backup modem for internet traffic by my boss.He wants a whole shitload of stuff on it (at least two wireless SSID's, VPN's, god knows what else) which I can mainly figure o...

darren.g by Level 5
  • 3384 Views
  • 8 replies
  • 0 Helpful votes

I am tasked with migrating our WAN from Microwave T1 multilinks (2 each endpoint), over to a fiber backbone.  We are getting 100Mb at each site with 1 fiber port from the provider.  My supervisor doesn't want to "re-invent the wheel" but wants to get...