IAD2431 Load IOS

[nshoe18]

I have an IAD2431 that the IOS has been deleted off of and I am trying to load via the Compact Flash but I keep getting errors and it will nto load. Any ideas on best way to load the IOS from ROMMON?

[ccbootcamp]

What kind of errors are you getting from the CF? I suppose you could always do an XMODEM from ROMMON (assuming that's available on the IAD).

-brad

www.ccbootcamp.com

(please rate the post if this helps!)

[paolo bevilacqua]

Type "tftpload" in rommon. It will tell you which parameters you have to set to load the image. To set a parameter, just type it followed by = and the value. Then connect the TFTP server to the lowest LAN and repeat the command, tftpload.

Hope this helps, please rate post if it does!

[nshoe18]

I am getting errors stating that the c2400-atafslib-m not found. I do not have an IP on the IAD so I do not think I can TFTP the IOS to it. I am trying to do it via XMODEM which of course is about a 4 1/2 hour process

[paolo bevilacqua]

Exactly because of length via xmodem, TFTP is provided. The IP is given at the time you config as mentioned above.

Hope this helps, please rate post if it does!

[nshoe18]

OK after I did the TFTPDNLD I get the output in the attached Text Doc.

[paolo bevilacqua]

I don't seen rommon prompt or tftpdnld command in the file included. When turning on the router, send one or two breaks from the terminal program, and this will give you rommon.