Hi
I have two sla monitors setup (in lab at the moment) to ping two external IP addresses. If both the addresses fail to respond, I want to change my default route to use 172.16.68.37. If/when either of the destination IP addresses come back up, I want the original default route 172.16.68.3 to be preferred instead.
Here is my relevant config:
ip sla monitor 1
type echo protocol ipIcmpEcho 195.155.0.1 source-interface FastEthernet0/0
frequency 10
ip sla monitor schedule 1 life forever start-time now
ip sla monitor 2
type echo protocol ipIcmpEcho 125.200.1.1 source-interface FastEthernet0/0
frequency 10
ip sla monitor schedule 2 life forever start-time now
track 1 rtr 1 reachability
delay down 30 up 30
!
track 2 rtr 2 reachability
delay down 30 up 30
!
track 3 list boolean and
object 1 not
object 2 not
ip route 0.0.0.0 0.0.0.0 172.16.68.37 track 3
ip route 0.0.0.0 0.0.0.0 172.16.68.3 50
Ok - so what happens?
If I take one of the external IP's down nothing changes = good
If I take both of the external IPs down, the existing default route is changed to use 172.16.68.3 = good
My problem is - when one (or both) of the external IPs come back, the SLA config appear not to detect this - an output of "show track" shows that for both monitors, the reachability is down.
Any ideas what I'm doing wrong?
cheers
