cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6153
Views
0
Helpful
1
Replies

ipv6 and subnet router anycast

Wassim Aouadi
Level 4
Level 4

I have switch DSW1 connected through its fastEthernet interface f0/0 to router R4 fastEthernet f0/0.

Configuring IPv6 on router is successful. When configuring IPv6 on DSW1's interface, it says the following:

DSW1(config-if)#
DSW1(config-if)#ipv6 add 2026::2:2/122 eui-64
%FastEthernet0/0: Warning: 2026::2:0/122 is a Subnet Router Anycast
DSW1(config-if)#

any idea?

1 Accepted Solution

Accepted Solutions

Nagendra Kumar Nainar
Cisco Employee
Cisco Employee

Hi,

When you use EUI-64 option, you need to allow 64 bits for host id. So try "ipv6 addr 2026::2:/64 eui-64". This should work.

Regards,

Nagendra

View solution in original post

1 Reply 1

Nagendra Kumar Nainar
Cisco Employee
Cisco Employee

Hi,

When you use EUI-64 option, you need to allow 64 bits for host id. So try "ipv6 addr 2026::2:/64 eui-64". This should work.

Regards,

Nagendra

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco