Hi Friends,
My switch is showing me primary SUP as disabled
Here is the output of show module all
_Switch#sh mod all
Chassis Type : WS-C4510R-E
Power consumed by backplane : 40 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
5 Supervisor
6 6 Sup 6-E 10GE (X2), 1000BaseX (SFP) WS-X45-SUP6-E JAE13177W7U
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
5 Unknown Unknown Unknown Other
6 0025.8466.4206 to 0025.8466.420b 1.2 12.2(44r)SG 12.2(52)SG Ok
Mod Redundancy role Operating mode Redundancy status
----+-------------------+-------------------+----------------------------------
5 Standby Supervisor SSO Disabled
6 Active Supervisor SSO Active
show redundancy
Redundant System Information :
------------------------------
Available system uptime = 2 days, 13 hours, 58 minutes
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Simplex
Configured Redundancy Mode = Stateful Switchover
Operating Redundancy Mode = Stateful Switchover
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Switch#show redundancy states
my state = 13 -ACTIVE
peer state = 1 -DISABLED
Mode = Simplex
Unit = Primary
Unit ID = 6
Redundancy Mode (Operational) = Stateful Switchover
Redundancy Mode (Configured) = Stateful Switchover
Redundancy State = Non Redundant
Maintenance Mode = Disabled
Manual Swact = disabled (system is simplex (no peer unit))
Communications = Down Reason: Simplex mode
client count = 57
client_notification_TMR = 240000 milliseconds
keep_alive TMR = 9000 milliseconds
keep_alive count = 0
keep_alive threshold = 18
RF debug mask = 0x0
