good day,
i'm trying to configure Speed Limit on Cisco router ISR 886VA. I have read this article, and understood that i have to use polices instead of shaping because in need limit incoming speed for a host. That i'm doing:
access-list 102 permit ip any host 10.254.1.4
class-map match-all Mikrotik-Dev
match access-group 102
policy-map Hosts
class Mikrotik-Dev
bandwidth 35000
But when I link this policy on WAN interface I get an error:
(config)#interface ethernet 0
(config-if)#service-policy input Hosts
Bandwidth command not allowed at parent level in input direction
How can I limit the incoming speed for a host?
Thank you!