Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we have several C9500-48Y4C, 16.9.4 and monitore them with SNMP. 20 days ago one switch stopped sending reqests to our monitoring tool. After a short research, I found that the SNMP input queue increases as soon as I restart SNMP and refresh th...
Hi everyone.we have Switch C9500-48Y4C and several Switches C9200-24T are connected to it.On the Switch C9500-48Y4C I see in- and outgoing traffic to other switches:#sh inter Twe 1/0/3
TwentyFiveGigE1/0/3 is up, line protocol is up (connected)
Hard...
Hello,
I've got an email from our ISP, that our router is in danger... They found that the router has SNMP port opened. After that, I scanned our router I found more opened ports: UDP 161, 123, 500 (it is OK, the router does S2S).
Could you please ch...
Hello,
We use ISR 886VA as Internet Router via VDSL.Now we need to switch this router to use FastEthernet as WAN port. Here is the current configuration:
interface Ethernet0
description WAN
no ip address
ip nbar protocol-discovery ipv4
service-po...
Hello,
I try to configure the IKEv2 tunnel between ASA 5510 and ISR 886VA using this article, scenario one. I have configured it, but i have a few questions:
1) what is the address 10.10.10.1 ? there is no such IP address on the scheme:
2) how can i...
Hello @Giuseppe Larosa I tried both orders - the result is always the same: #sh snmp view
OMD iso - included nonvolatile active
OMD entSensorType - excluded nonvolatile active
cac_view pimMIB - included read-only active
cac_view msdpMIB - included re...
