04-25-2009 06:50 AM - edited 03-04-2019 04:31 AM
Hi,
I have a router with 2 WAN connections, One 2 MB E1 terminated to serial link and another wireless link terminated to Ethernet. Is it possible to load balance between the two. If so how?
thanks in advance
Rajesh
04-25-2009 08:36 AM
Rajesh
Yes you should be able to do this. If the links are the same speed then a dynamic routing protocol could be used and as long as it saw both links to the same destination it would use both.
If the links are a different speed you could use 2 static routes one for each link. Bear in mind though that if one link is much faster than the other you may be better off using the slower link purely as a backup.
Jon
04-25-2009 08:02 PM
Dear Jon,
Thanks a lot
rgds
rajesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide