Routing

Hi All, I have a 1721 router with a WIC 4ESW 4 port switch card and an integrated T1 controller. I have a T1 to the core of my network going into this Cisco 1721 router. I need have all the devices plugged into the 4 port switch on one network and th...

Hi all,I have a MLPPP with 2 T1's connecting the main branch and a remote branch. I called the telco to let them know I would be setting these T1's up as a multilink, incase they needed to do anything different. They told me nothing needed to be ch...

Hi Guys, I already posted a case before 2 weeks describing what is happening with me regarding those VWIC2-2MFT-G703 cards I have and I am creating a new case now because I got another info that may help detecting this issue.I have this error message...

Hi All, I have a 2811 with a Network Module (NM-2CE1T1_PRI).I want to understand the configuration of my router (please see document attached). I understand this is a Network Module that has to E1 ports.There's one E1 that's configured but it is divi...

Hi Everybody,I need a clarification on the behaviour of BGP with equal cost path (maximum-paths 2)I have 1841 Router with Dual leased line named my ISP named ISP-1. I was runnning BGP between my router(AS 500) & ISP-1 (AS100). Since the two links are...

Hello all,We are having multiple links to our core site using bgp .one is shdsl and other is fiber.We have bgp and As no. provided by ISP .BGP is taken care by isp.on our remote site we have 2 interfaces configured with wan ips and as no.Both wan ips...

I have two routers connected by FR. One is physical interface and the other is sub-interface multipoint. But the VC is not coming up unless I use point-to-point. Please whats the reason.

Hi, Can anyone help me in how to decide the multicast scope. Putting it in simple way I have 4 Routers R1--R2--R3--R4. R1 is configured as RP and I need to configure scope in such a way that Multicasting doesnot forward after R4.Whether I have to co...

I hope that I will see some of you at Cisco Live in San Francisco. I will be at the conference taking some classes and spending some time in the Chesapeake NetCraftsmen booth. I hope that many of you will be able to be at the conference and that I wi...

I want block to Pc from communicating in the same vlan

Dear All Expert,I would like to ask you some question about,i would like control bandwidth on user.so some user allow 10kbps and some user allow 50kbps for access internet ( outside). Please help me to let me know how can i do on this?Best Regards,Re...

I have two routers connect through FR and F0/0. I change the bandwidth on the FR to 100000 to load balance between the two links. And also the hello to 2 sec and dead timer to 8 sec on both. But ever since then the adjacency on the two link keep goin...