Logging Not Displayed

[Carlton Patterson]

Hello Community,

I've set up my GNS3 router to log to console and terminal monitor at debug level, see below. However, when I can't see any logs. Can someone shed some light on the reason why?

Cheers

Carlton

R4#show logg
Syslog logging: enabled (11 messages dropped, 0 messages rate-limited,
                0 flushes, 0 overruns, xml disabled, filtering disabled)
    Console logging: level debugging, 67 messages logged, xml disabled,
                     filtering disabled
    Monitor logging: level debugging, 0 messages logged, xml disabled,
                     filtering disabled
    Buffer logging: disabled, xml disabled,
                    filtering disabled
    Logging Exception size (4096 bytes)
    Count and timestamp logging messages: disabled

No active filter modules.

    Trap logging: level informational, 82 message lines logged
        Logging to 192.168.1.1(global) (udp port 514, audit disabled,  link up), 82 message lines logged, xml disabled,
               filtering disabled
R4#

[stephen.stack · Accepted solution]

Add the logging buffered command. Example below

logging buffered 30000 informational

==========================
http://www.rConfig.com 

A free, open source network device configuration management tool, customizable to your needs!

[Carlton Patterson]

Stephen

Thanks

Carlton